Announcement Announcement Module
No announcement yet.
Fuel Injection for AMC 150 Page Title Module
Move Remove Collapse
Conversation Detail Module
  • Filter
  • Time
  • Show
Clear All
new posts

  • Fuel Injection for AMC 150

    Is there a fuel injection system capable of bolting to the AMC 150 in an '85 CJ-7? The Jeep has 28,000 original miles, no rust, and all the parts so I am a little reluctant to swap motors. However that little motor just doesn't quite have enough power. Any suggestions?

  • #2
    according to jeeptech, that's the same 4cyl used in current jeeps. the original motor had a carb, they switched to TBI (throttle body injection) for a while, and currently use multi-port injection. assuming the writer of that website is not on crack (i've found his "tech" to be on track in the past), you should be able to bolt the multi-port or TBI system from a newer motor right on to yours.


    • #3
      I have read that the motors are the same, I wondered if there were some small odd differences in the block that would prevent bolting the system on. I'll check out the jeeptech. Thanks again!