Announcement Announcement Module
Collapse
No announcement yet.
350 th350 conversion Page Title Module
Move Remove Collapse
X
Conversation Detail Module
Collapse
  • Filter
  • Time
  • Show
Clear All
new posts

  • 350 th350 conversion

    I've completed the conversion! I will post pics later this weekend. I drove it last night for the first time and everything is working great minus a power steering fluid leak in the hose and a small carb problem.

    The carburator is an Edel. 1405 600cfm. Timing is set to a total 32 degrees. The mixture screws have been adjusted to near factory spec. The motor wont cold start unless i put a little fuel in by hand. Once it starts, runs fine, and will start again. Doesn't want to cold start. I looked down the carb while turning it over and there is a very small amout of fuel being pumped in. Any ideas what it could be??

  • #2
    Sounds like the choke is not adusted properly. The instuctions that came with the carb should detail how to adjust the choke. Being a carb you will have to pump the throttle a couple times when you cold start, that is normal. Pumping the throttle resets all the linkages to the cold start position, again assuming the choke is adjusted properly.

    Comment


    • #3
      Your right again. After some adjustments started right up.
      Thanks

      Comment

      Working...
      X