Announcement Announcement Module
No announcement yet.
T-176 w/Chevy V8 Page Title Module
Move Remove Collapse
Conversation Detail Module
  • Filter
  • Time
  • Show
Clear All
new posts

  • T-176 w/Chevy V8

    I was just wondering if there would be any problems using my T-176 tranny with a 300 horse Chevy 350? I know that the T-176 was originaly designed for the AMC V8, but I'm not sure if it will convert well with a Chevy block. Has anyone here tried this before?

  • #2
    My 176 has held up just fine with my 375 horse 360 AMC.


    • #3
      Jeepcat, how did you get 375 horse power out of a 360? Did you have some head work done and what kind of camshaft did you use? I have a '79 304 with a 600 Holley and an Edelbrock Performer intake. This thing is a boat anchor. I'm lookong for a 401.

      tomcasino from St. Paul, MN


      • #4
        I got 375 horses out of my 360 through very extensive head work.I am a machinist.I bored the mill over , fitted with new pistons.The heads were ported and polished,fitted with bigger valves.The cam is as steep as I could find,and the motor LOVES fuel.E-mail me and I will send you some pics. The crank had mass work done also.