Announcement Announcement Module
Collapse
No announcement yet.
Transplanted 360 Page Title Module
Move Remove Collapse
X
Conversation Detail Module
Collapse
  • Filter
  • Time
  • Show
Clear All
new posts

  • Transplanted 360

    I'm about to transplant a 360 AMC in place of the 304 into my '76 CJ5. A couple of questions:
    Will my old clutch attach to a 360 flywheel?
    Will the 727TF that is currently attached to the 360 mate to my D20 without an adapter?
    If so, will I have to modify my driveshafts?

  • #2
    727 t/f to dana 20

    i'm going through that same combination. as far as i know they won't go together without an adapter. i got my tranny from art carr, they sent me two adapters they both bolted two the 727 no problem, but only one had the same bolt pattern as the dana 20. so i put that one on, well when it was bolted together the output shaft from the tarnny did'nt even make it past the bearing inside the adapter. they told me to use the other one and there gonna send an other adapter to put between the first one. and there gonna send me a little shaft to put over the output shaft (23 spline). because the adapter that had the same bolt pattern as the 727 but not the dana 20, the output shaft did make it past the bearing in the adapter. here's pictures of the two different adapters , you'll see what i mean. i'll let you know how it works out. there a good company so it should work.
    http://i88.photobucket.com/albums/k1...4/DSC00207.jpg
    http://i88.photobucket.com/albums/k1...4/DSC00204.jpg
    http://i88.photobucket.com/albums/k1...4/DSC00203.jpg

    Comment

    Working...
    X