Announcement Announcement Module
Collapse
No announcement yet.
help need to hot wire my jeep Page Title Module
Move Remove Collapse
X
Conversation Detail Module
Collapse
  • Filter
  • Time
  • Show
Clear All
new posts

  • help need to hot wire my jeep

    Does anyone know how to hot wire a 1976 CJ5? Keyed ignition switch shot!
    plastic gear in the housing disintegrated.

  • #2
    Point ignition or electronic?

    Comment


    • #3
      electronic

      Comment


      • #4
        Sorry, I'd be guessing. Someone should know. DP

        Comment


        • #5
          Yooper

          Good to see another yooper on the forum. The flat connector under you dash on the steering colum. The lt. blue wire go to the starter solenoid. Connector # is 14. Does anything work when you turn the key. You could run a push button switch for the ignition. Run a fused wire to the switch and a wire to the LT. blue wire. That should start and stop the engine. Not sure about the rest of the keyed fuctions. Got the termial and wire color out of my Haynes manual page 10-18. Hope that helps.

          Comment


          • #6
            You can run a wire from the battery side of your solenoid to the "I" post on your battery then touch a screwdriver from the battery side to the "S" post.

            Comment


            • #7
              Answer your PM. I will not post how to hot wire a jeep on the public forum. Too easy to have a jeep get stolen. No need to give anyone directions.

              Comment


              • #8
                Lost-one

                I see what your gettin at. If a jeep was to get stolen, The people doing the taking would know how, much better then we would anyway

                Comment


                • #9
                  So Ritzyooperman, did you get my PM?
                  Did you get it to work?

                  Comment

                  Working...
                  X